1. First, clean up the decoration waste left on the site;
2、由上到下全面吸尘；
2. Dust collection from top to bottom;
3、擦玻璃：先用毛巾把玻璃框擦拭干净，再用涂水器沾稀释后的玻璃水溶液，均匀的从上到下涂抹玻璃，有顽固的污渍用铲刀清除干净，再重复以上工序后用刮子从上到下刮干净，用干毛巾擦净框上留下的水痕，玻璃上的水痕用机皮擦拭干净。
3. Wipe the glass: first wipe the glass frame with a towel, then dip the diluted glass water solution with the water applicator, and evenly smear the glass from top to bottom. If there are stubborn stains, clean them with a shovel. After repeating the above process, scrape it from top to bottom with a scraper, wipe the water marks on the frame with dry towel, and wipe the water marks on the glass with machine skin.
4、卫生间：坚持由上而下的原则，首先认清卫生间顶子的材质，是PVC的或是铝塑板还是涂料的，再根据不同的材质用不同的清洁方法进行清洁；用清洁球或是板刷清洗卫生间的墙壁，着重瓷砖的缝隙，和瓷砖表面上遗留的胶迹、涂料点、水泥渍等；用毛巾清洁卫生间的洁具，用不锈钢清洗液针对各种龙头、管件进行清洁；用洗地机对地面进行最后的清洁，由其是地面的边角，用清洁球和刀片对洗地机洗不到的角落进行针对性的除污、去除水泥渍等；最后，检查无遗漏后，再用干毛巾把水龙头等管件擦拭一遍。
4. Toilet: adhere to the principle of from top to bottom, first recognize the material of toilet top, is PVC or aluminum plastic board or coating, and then according to different materials, use different cleaning methods to clean; use cleaning ball or board brush to clean the wall of toilet, focus on the gap of ceramic tile, and the glue mark, paint spots, cement stains left on the surface of ceramic tile; clean sanitation with towel Clean all kinds of faucets and pipe fittings with stainless steel cleaning solution; clean the floor with the floor washer, which is the corner of the floor, and use cleaning balls and blades to remove the dirt and cement stains on the corners that can not be washed by the floor washer; finally, wipe the faucet and other pipe fittings with dry towel after checking if there is no omission.
5、厨房：程序同上。注意：因厨房里的不锈钢管件比较多，应是清洁重点。
5. Kitchen: same procedure as above. Note: because the kitchen stainless steel pipe fittings are more, should be the key point of cleaning.
6、卧室及大厅：墙壁用掸子或是吸尘器做除尘处理，擦拭灯具、开关盒、排烟置、空调口、排风口等。
6. Bedroom and Hall: the walls are dusted with dusters or vacuum cleaners, and lamps, switch boxes, smoke exhaust devices, air conditioning outlets, exhaust outlets, etc. are wiped.
7、门及框：分清门的材质，用专业清洁剂稀释后，用毛巾擦拭，程序也是从上到下，把毛巾叠成方块，从门的顶部开始从左到右的擦拭，不能有遗漏，有胶渍的地方可用除胶剂做处理；框的程序同门；一定要做到无遗漏、无死角。
7. Door and frame: distinguish the material of the door, dilute it with professional detergent, and wipe it with towel. The procedure is from top to bottom, fold the towel into square, and wipe it from the top of the door from left to right. There should be no omission. The place with glue stain can be treated with glue remover. The procedure of frame is the same as that of door. Make sure there is no omission and dead corner.
8、地面的清洗：把所有的做完以后，就是地面的清洗了，地面也要分材质，是木地板的、还是瓷砖的、或是石材的，当分清后就选择专用清洁剂稀释后，开始清洗。地面上的胶渍可用刀片清除，顽固的可用去胶剂处理；最后一道工序做完后，应由领班全面检查一遍后，确认无遗留后撤离现场。
8. Floor cleaning: after finishing all the cleaning, the floor should also be divided into wood floor, ceramic tile, or stone. After separation, choose special detergent to dilute and start cleaning. The glue stains on the ground can be removed by blade, and the stubborn ones can be treated with glue remover; after the last process is completed, the foreman shall conduct a comprehensive inspection and leave the site after confirming that there is no left.
9、地角线：用毛巾擦拭，用刀片去掉各种胶迹、涂料点等。
9. Corner line: wipe with towel, remove all kinds of glue and paint spots with blade.
